TGA Thermal Gravimetric Analyzer Thermal Analysis Machine DSC Tester Laboratory Device for Plastics And Rubber GA-1901-A
Product Introduction
Thermogravimetric analysis (TG, TGA) is to observe the change of sample mass with temperature or time in the process of temperature rise, constant temperature or cooling, in order to study the thermal stability and composition of materials. Widely used in plastic, rubber, coating, drugs, catalysts, inorganic materials, metal materials and composite materials and other fields of research and development, process optimization and quality control.
Measure and study the following properties of materials:
Thermal stability, decomposition process, adsorption and desorption, oxidation and reduction, quantitative analysis of components, additives and fillers
TGA Thermal Gravimetric Analyzer Thermal Analysis Machine DSC Tester Laboratory Device for Plastics And Rubber GA-1901-A
Structural advantages:
1. Furnace body heating adopts precious metal platinum rhodium wire double row winding system, reduce interference.
2. The tray sensor is made of precious metal platinum rhodium alloy, which has the advantages of corrosion resistance.
3. Power supply, the circulation cooling part is separated from the main engine to reduce the influence of heat and vibration on the microthermal balance.
4. The upper open cover structure is convenient to operate. It is very difficult to put samples in the upper moving furnace body, and it is easy to damage the sample bar.
5. The host machine adopts water constant temperature device to isolate the thermal influence of the heating furnace body on the chassis and micro thermal balance.
6. Furnace body can be replaced according to customer requirements
Controller and software advantages:
1. Using imported 32-bit ARM processor Cortex-M3 kernel, sampling speed, fast processing speed.
2.24-bit four-way sampling AD collects DSC signal, TG signal and temperature T signal.
3. Power supply and water circulation part, independently controlled by 8bit single chip microcomputer, so that the main engine and cooling part separate, do not interfere with each other, but they are closely connected, cooling part accept the control of the main engine.
4. USB two-way communication is adopted between the software and the instrument to fully realize remote operation. The parameter setting and operation stop of the instrument can be carried out through computer software.
5.7-inch full-color 24bit touch screen, good man-machine interface. TG calibration can be realized on the touch screen
TGA Thermal Gravimetric Analyzer Thermal Analysis Machine DSC Tester Laboratory Device for Plastics And Rubber GA-1901-A
Technical parameters:
1. Temperature range: room temperature ~1450ºC
2 temperature resolution: 0.01ºC
3 temperature fluctuation: ±0.1ºC
4. Heating rate: 0.1~100ºC/min
5. Temperature control mode: heating, constant temperature, cooling
6. Cooling time: 15min (1000ºC... 100 ºC)
7. Balance measurement range: 0.1mg ~ 2G, can be extended to 30g
8. Accuracy: 0.01mg
9. Constant temperature time: 0 ~ 300min arbitrary setting
10. Display mode: Large LCD display of Chinese characters
11. Atmosphere device: built-in gas flowmeter, including two gas switch and flow size control
(Atmosphere: inert, oxidizing, reducing, static, dynamic)
12. Software: The software can automatically record TG curves for data processing and print experimental reports
13. Data interface: standard USB interface
14. Power supply: AC220V 50Hz
15. Optional constant temperature water cooling
Audited Supplier 
){kind=link}